01
Phone Intake
You call (833) 929-5837 and describe what you are seeing or smelling. We ask about water damage mold history, roof leaks, and any HVAC mold contamination. That conversation decides how many sample locations you actually need, which keeps the cost down.
02
Walkthrough and Moisture Map
On site, we run a moisture meter across suspect walls and use a thermal imaging camera to spot cool zones. A boroscope inspection camera goes into any cavity that reads wet. This takes 20 to 30 minutes and tells us where to place cassettes.
03
Air and Surface Sampling
We set up a calibrated air sampling pump with spore trap cassettes, one per room plus an outdoor control. Each location runs five to ten minutes at a fixed flow rate. Where we see visible growth, we also take a tape lift or swab for direct identification.
04
Lab Analysis
Samples go to an accredited third-party lab. Technicians identify spores to genus level and count them per cubic meter of air. Turnaround is 24 to 48 hours on standard service, and we can request rush handling when a real estate deadline is pressing.
05
Report Review
We walk you through the report: which genera showed up, how indoor counts compare to outdoor, and what the numbers mean for your next step. If remediation is warranted, we scope it. If the air is clean, we tell you that too and you save the money.